Description
Technical Specifications and features of Power Module
The Cisco 800-IL-PM-2 is a power module for 800 series routers. Here are its technical specifications and features:
- Power Input: 100-240V AC, 50/60 Hz.
- Output Power: 60W.
- Output Voltage: 12V DC.
- Power Connector: Standard IEC 320-C6 Connector.
- Compatibility: Compatible with 800 series routers, including 880, 890, and 800M series routers.
- Environmental: Operating temperature range of 32°F to 104°F (0°C to 40°C) and storage temperature range of -13°F to 158°F (-25°C to 70°C).
- EMI/EMC: Meets FCC Class B and CE requirements for electromagnetic interference/electromagnetic compatibility.
- Safety: Meets UL 60950-1, CSA C22.2 No. 60950-1, and EN 60950-1 standards for safety.
Installation and Setup of Power Supply
As a language model AI, I don’t have personal experiences but here is the procedure to install and set up the 800-IL-PM-2 Cisco Power Module for 800 Series Router:
- Unpack the power module and check for any damage.
- Remove the power supply from the router by loosening the thumbscrews that secure it in place.
- Connect the power supply cable to the power module.
- Slide the power module into the power supply slot on the router until it clicks into place.
- Tighten the thumbscrews on either side of the module to secure it in place.
- Connect the power cord to the power module and plug it into an electrical outlet.
- Power on the router and wait for it to initialize.
- Connect to the router using the console cable and log in to the router’s command-line interface (CLI).
- Enter the command “show power” to display the status of the power module and ensure it is functioning properly.
- If necessary, use the “power inline auto” command to configure the power module for automatic power supply selection.
Troubleshooting and Maintenance
As a language model AI, I don’t have experience with the product but I can provide information based on the manual.
Troubleshooting the 800-IL-PM-2 Cisco Power Module for 800 Series Router involves several steps to resolve any issues. Some common problems and their solutions include:
- No Power: Check if the power cord is properly plugged into the module and the wall outlet. If the issue persists, check the power source for any damage.
- Power Overload: The module has a power overload protection feature, which may trigger if the load exceeds the rated capacity. Check if any device connected to the module is drawing too much power.
- Power Failure: Check if the power source is stable and check the power cord for any damage. If the issue persists, replace the power cord.
- Power Supply Error: Check if the power supply voltage is within the specified range. If not, adjust the voltage or replace the power supply.
General Information
- Manufacturer: Cisco
- Manufacturer Part Number 800-IL-PM-2
- Product Name 2 Port Power over Ethernet Injector
- Product Type PoE Injector
- Output Voltage 48 V DC
- Output Ports 2 x RJ-45
