Description
Installation and Configuration
- Begin by unboxing the 784629-001 HPE 8sff Smart Array H240 Cable Kit and verifying that all components are present and in good condition.
- Power down the DL380 Gen9 server and disconnect all cables and peripherals.
- Open the server’s access panel to reveal the internal components.
- Locate the Smart Array H240 controller card and remove it from the server by releasing the retention clips and gently pulling it out.
- Replace the Smart Array H240 controller card with the new one included in the 784629-001 kit.
- Connect the cables included in the kit to the appropriate ports on the controller card and the server’s internal drive bays.
- Close the server’s access panel and reconnect all cables and peripherals.
- Power on the server and enter the BIOS setup to verify that the new controller card is recognized and configured correctly.
- Use the HPE Smart Storage Administrator software to create and configure RAID arrays as needed.
- Finally, install and configure the operating system and any necessary drivers and software to complete the installation and configuration of the 784629-001 HPE 8sff Smart Array H240 Cable Kit for DL380 Gen9 Server.
Troubleshooting and Maintenance
Troubleshooting:
- Check the cable connections to ensure they are securely plugged in.
- Check the firmware of the Smart Array controller to ensure it is up-to-date.
- Check the configuration of the array in the BIOS settings to ensure it is correct.
- Check the disk drive status to ensure they are functioning properly.
- Check for error messages in the system logs.
Maintenance:
- Regularly check the cable connections to ensure they are secure and not loose.
- Keep the firmware of the Smart Array controller up-to-date by checking for updates and applying them as needed.
- Perform regular backups to ensure data is protected.
- Monitor the disk drive status and replace any failing drives as needed.
- Clean the server regularly to prevent dust buildup which can cause overheating and damage to components.
Data Transmission Capabilities
The 784629-001 HPE 8sff Smart Array H240 Cable Kit for DL380 GEN9 Server is designed to provide data transmission capabilities for the DL380 GEN9 Server. The kit includes two cables that connect the server’s Smart Array H240 controller to the eight small form factor (SFF) drive bays. These cables are designed to provide high-speed data transfer between the controller and the drives, allowing for fast and efficient data access and storage. The kit also includes a cable management arm that helps to organize and secure the cables, ensuring that they remain in place and do not become tangled or damaged. Overall, the 784629-001 HPE 8sff Smart Array H240 Cable Kit for DL380 GEN9 Server provides a reliable and high-performance data transmission solution for the DL380 GEN9 Server.
General Information
- Manufacturer: Hewlett Packard Enterprise (HPE)
- MPN: R0Z25A
- SKU: R0Z25A
- Product Type: Network Cable
Technical Information
- Cable Type: QSFP28
- Cable Length: 3.3 feet
- Connector on First End: 1 x QSFP28 Network
- Connector on Second End: 1 x QSFP28 Network
- Device Supported: Network Device
- Data Transfer Rate: 100 Gbit/s
Physical Characteristics
- Weight (Approximate): 4.32 oz