Description
Interface and Connectivity
The 5H4YH Dell QLE2742 FC PCI-E 3.0 ×8 Dual-Port 32GB Low Profile HBA has the following interface and connectivity specifications:
- Host Interface: PCI-E 3.0 ×8
- Data Transfer Rate: 32Gbps
- Ports: 2 FC ports
- FC Data Rate: 32Gbps
- FC Port Type: SFP+
- Connectivity: Dual-port
- Form Factor: Low profile
Management and Monitoring Tools
The 5H4YH Dell QLE2742 FC PCI-E 3.0 ×8 Dual-Port 32GB Low Profile HBA has the following interface and connectivity specifications:
- Host Interface: PCI-E 3.0 ×8
- Data Transfer Rate: 32Gbps
- Connectivity: Dual-port Fibre Channel
- FC Data Transfer Rate: 32Gbps full duplex
- Protocol Support: Fibre Channel
- Form Factor: Low profile
- Operating Temperature: 32°F to 140°F (0°C to 60°C)
- Humidity: 20% to 80% non-condensing
- Operating Altitude: 0 to 10,000 feet (0 to 3,048 meters)
Installation and Configuration
Here are the general steps for installing and configuring the 5H4YH Dell QLE2742 FC PCI-E 3.0 ×8 Dual-Port 32GB Low Profile HBA:
- Check the compatibility: Before installing the HBA, make sure that your server is compatible with the HBA and the operating system you are using.
- Power off the server: Turn off the server and disconnect all cables, including the power cables, before installing the HBA.
- Install the HBA: Physically install the HBA in an available PCI-E slot and secure it with the screw provided.
- Power on the server: Connect the power cables and turn on the server.
- Load the HBA driver: The HBA driver can be downloaded from the Dell website. Load the driver and follow the installation instructions.
- Verify the HBA installation: Use the server’s device manager to verify that the HBA has been installed and is functioning properly.
- Configure the HBA: Configure the HBA settings such as the World Wide Name (WWN) and the target ID using the HBA’s management software.
General Information
- Manufacturer: Dell
- MPN: 5H4YH
- Type: Controller
- Controller Type: Fiber Channel
Technical Information
- Bus Interface PCIE 3.0 ×8 (Dual-Port)
- Host Interrupts Intx And Msi-x
- PCI Express Base Specification, Rev. 3.1
- PCI Express Card Electromechanical Specification, rev. 3.0
- PCI Bus Power Management Interface Specification, rev. 1.2
- Throughput 32GBPS Line Rate per Port (Maximum)
- Loginssupport For 2,048 Concurrent Logins And 2,048 Active Exchanges Per Port
Compliance
- Scsi-3 Fiber Channel Protocol (SCSI-FCP)
- Fiber Channel Tape (FC-Tape) Profile
- SCSI Fiber Channel Protocol-2 (FCP-2)
- Second Generation FC Generic Services (FC-GS-2)
- Third Generation FC Generic Services (FC-GS-3)
- PCI Hot Plug Specification, Rev. 1.1
- Fiber Channel-physical Interface-5 (FC-PI-5)
- Fiber Channel-physical Interface-6 (FC-PI-6)
- Boot Support Bios, Unified Extensible Firmware Interface (Uefi)
- Ports Dual-port FC
- Form Factor Low-profile PCIE Card (6.6 Inches × 2.731 Inches)
Temperature
- Operating: 0°c/32°f To 55°c/131°f
- Storage: –20°c/–4°f To 70°c/158°f
Humidity
- Relative (Noncondensing): 10% To 90%
- Storage: 5% To 95%
-324x324.jpg)
