Description
Memory Type and Pin Configuration
Memory Type: The UCS-ML-128G4RT-H Cisco 128GB memory module is DDR4 SDRAM (Synchronous Dynamic Random Access Memory). DDR4 is a type of computer memory that is used in most modern computers and is an improvement over its predecessor DDR3, offering higher speeds and improved power efficiency.
Pin Configuration: The memory module has 288 pins and is a LRDIMM (Load Reduced Dual In-line Memory Module). The pin configuration of the memory module ensures compatibility with DDR4 memory sockets on motherboards. The 288-pin configuration is used for LRDIMMs, which are commonly used in server and high-performance computing systems. The pin configuration, also known as a form factor, is important because it ensures that the memory module will physically fit into the memory socket on the motherboard and function properly.
Energy Efficiency and Power Consumption
Energy Efficiency: The UCS-ML-128G4RT-H Cisco 128GB memory module is designed with energy efficiency in mind, utilizing DDR4 SDRAM technology. DDR4 is known for its improved energy efficiency compared to previous generations of DDR memory. This is achieved through a lower voltage of operation, which reduces the amount of power required to run the memory module.
By operating at 1.2V, compared to the 1.5V used by DDR3, the UCS-ML-128G4RT-H Cisco 128GB memory module consumes less power, resulting in reduced energy costs and improved thermal management for computer systems. This improved energy efficiency can also result in improved system reliability, as well as a longer lifespan for computer components.
Power Consumption: The power consumption of the UCS-ML-128G4RT-H Cisco 128GB memory module is dependent on several factors, such as the memory frequency, memory capacity, and the number of memory modules in use. However, in general, DDR4 memory modules consume less power than DDR3 modules. This reduced power consumption can result in improved system reliability, as well as longer lifespan for computer components.
It’s important to note that the power consumption of a memory module can also be affected by the computer system in which it is installed. For example, a computer system with multiple high-performance components may consume more power overall, regardless of the memory module’s power consumption. Therefore, it’s important to consider the entire computer system, not just the memory module, when evaluating power consumption and energy efficiency.
Installation and Setup Instructions
Cisco UCS-ML-128G4RT-H is a DDR4 memory module with 128GB capacity. Below are the steps to install and set up this memory module:
- Ensure the server is powered off and all cables are disconnected.
- Open the server casing.
- Locate the memory slots on the motherboard.
- Remove any existing memory modules from the slots, if any.
- Align the notches on the module with the notches on the slot and gently insert the module into the slot.
- Press down on the module until the locking clips click into place.
- Repeat steps 4-6 for any additional memory modules to be installed.
- Close the server casing and connect all cables.
- Power on the server.
- Enter the server’s BIOS or UEFI to verify the memory has been recognized and configure the memory settings if necessary.
- Install the operating system and necessary drivers.
General Information
- Manufacturer: Cisco
- Manufacturer Part Number: UCS-ML-128G4RT-H
- Product Name: 128GB DDR4 Sdram Memory Module
Technical Information
- Storage Capacity: 128GB
- Memory Technology: DDR4 Sdram
- Number Of Modules: 1 X 128GB
- Bus Speed: 2933mhz DDR4-23400/PC4-2933
- Data Integrity Check: Ecc
- Signal Processing: Registered
- Cas Latency Timings: Cl24
- Rank Features: 4rx4





