Description
Installation and setup SCSI
The installation and setup of a Dell SCSI hot swap hard drive sled tray bracket for Poweredge and Powervault servers is a straightforward process that can be completed in a few steps. Here’s how:
- Gather tools and materials: Before you begin the installation, gather the necessary tools and materials. You’ll need the hot swap drive tray, a screwdriver, and any mounting screws that may have been included with the tray.
- Remove the old drive: To install the hot swap drive tray, you’ll first need to remove the old drive from the server. Depending on the server, this may require the removal of a few screws or the release of a locking mechanism.
- Mount the new tray: Once the old drive is removed, attach the hot swap drive tray to the server by securing it with the screws that were provided.
- Insert the SCSI drive: With the hot swap drive tray attached to the server, you can now insert the SCSI drive into the tray. Depending on the design of the tray, this may involve releasing a locking mechanism or simply sliding the drive into place.
- Connect the cables: Finally, connect any necessary cables to the SCSI drive. This will typically include a power cable and a SCSI data cable.
- Boot the server: With the SCSI drive installed and connected, boot the server to ensure that the drive is recognized and operational.
The entire process should take just a few minutes and require no special technical expertise. With the SCSI hot swap drive tray installed, you’ll be able to easily swap out SCSI drives in your server without having to shut down the system or disrupt service.
Specifications and Dimensions
The Y6939 Dell SCSI hot swap hard drive sled is a bracket specifically designed for use with Dell PowerEdge and PowerVault servers. This sled allows for easy installation and removal of SCSI hard drives in a hot-swap configuration.
Here are the specifications:
- Compatibility: Dell PowerEdge and PowerVault servers
- Drive Type: SCSI Hard Drive
- Connector Type: 68-pin SCSI
- Hot-swap capable: Yes
Dimensions:
- Length: 8.66 inches (220mm)
- Width: 4.13 inches (105mm)
- Height: 1.61 inches (41mm)
Maintenance and troubleshooting tips
Maintenance:
- Regular cleaning: Dust and debris can accumulate on the drive sled over time, causing it to fail. Regular cleaning of the drive sled can help prevent this issue.
- Check for loose screws: The screws that hold the drive in place can become loose over time. Check these screws periodically and tighten them if necessary.
- Check for physical damage: Inspect the drive sled for any physical damage that may have occurred during installation or use. Replace the sled if it is damaged.
Troubleshooting:
- Drive not detected: If the drive is not being detected by the server, check the connections and make sure that the drive is properly installed in the sled.
- Drive failure: If the drive fails, remove it from the sled and replace it with a new one.
- Sled failure: If the sled fails, it may need to be replaced. Make sure to check the connections and ensure that the sled is properly installed before replacing it.
- SCSI issues: If there are issues with the SCSI connection, check the cables and make sure they are properly connected. Check the SCSI card for any errors or problems and replace if necessary.
General information
- Part no. # y6939
- Manufacturer : Dell
Compatibility
- Poweredge 700, 800, 1600, 1600sc, 1800, 1850, 2600, 2650, 2800, 2850, 3250, 6600, 6650, 6800, 6850, 7150, series servers and powervault 220s, 221s, 220f, 650f, 660f scsi arrays
Key features
- Cabinet type : internal drive case
- Modules qty. : 1
- Storage controller :
- Supported devices : hard drive