Description
Power over Ethernet of Expansion Module
The J9547A HPE ProCurve 10/100 PoE+ v2 zl 24 Ports Expansion Module supports Power over Ethernet (PoE) capabilities, which allows power to be delivered to devices through the Ethernet cable, eliminating the need for additional power cables and outlets. This module supports PoE+ (IEEE 802.3at) with a maximum power budget of 370 watts, allowing for the power supply of high-power devices such as wireless access points and IP cameras. Additionally, the module also supports PoE-compliant devices, allowing for the power supply of devices such as phones and access points.
Maximize Network Capabilities
- Utilize all 24 ports to expand the network and increase the number of connected devices.
- Enable Power over Ethernet (PoE+) to power devices such as phones, cameras, and access points without the need for additional power sources.
- Utilize Quality of Service (QoS) to prioritize and manage network traffic for important applications and devices.
- Enable Link Aggregation Control Protocol (LACP) to increase the bandwidth and redundancy of the network by combining multiple ports into a single logical link.
- Utilize VLANs to segment the network and increase security and manageability.
- Enable SNMP and use a network management system to monitor and manage the module and connected devices.
- Utilize the module’s advanced security features such as access control lists and port security to protect the network from unauthorized access.
Troubleshooting and Support
- Verify that the module is properly seated in the ProCurve switch.
- Check that the module is properly powered. The LEDs on the module should be lit and the switch should recognize the module.
- Verify that the firmware on the switch and module are compatible. If not, upgrade the firmware to the latest version.
- Check the cabling and ensure that the cables are properly connected to the switch and the module.
- Check the switch’s port configuration and ensure that the ports on the module are configured correctly.
- Check the switch’s power supply and ensure that it is providing enough power to the module.
- Check for any error messages on the switch’s console or web interface.
- If the issue persists, contact HPE ProCurve support for further assistance.
General Information about the HPE J9547A
- Manufacturer: HPE
- Part Number or SKU# J9547A
- Type: Networking
- Module -Type: Expansion Module 48 Ports
Technical Information
- Form Factor : Plug-In Module
- Connectivity Technology : Wired
- Cabling Type : Ethernet 10Base-T, Ethernet 100base-Tx
- Data Link Protocol : Ethernet, Fast Ethernet
- Data Transfer Rate : 100 MBPS
- Features : Poe+
Expansion / Connectivity
- Interfaces : 24 X Network / Power – Ethernet 10base-T/100base-Tx – Rj-45
- Compatible Slots : Expansion Slot
