Description
Benefits of using
The J9735A HP 2920 1m Stacking Cable is a cable that allows multiple HP 2920 switches to be connected together and function as a single, larger switch. This provides several benefits, including:
- Increased port density: By connecting multiple switches together, you can increase the number of ports available for connecting devices.
- Simplified management: When multiple switches are connected together in a stack, they can be managed as a single entity, making it easier to configure and monitor the network.
- Increased resiliency: Stacking multiple switches together provides redundancy, so if one switch fails, the others in the stack can continue to operate and keep the network up and running.
- High-speed stacking: The J9735A HP 2920 1m Stacking Cable supports high-speed stacking, which allows for faster data transfer between switches in the stack.
- Cost savings: Stacking switches together can be more cost-effective than purchasing multiple individual switches.
The 3.28 ft length of the J9735A HP 2920 1m Stacking Cable is suitable for stacking switches that are in close proximity to each other and allows to connect the switches in a small area.
Maximum Stability
Maximum stability for the J9735A HP 2920 1m Stacking Cable for Network Device 3.28 ft can be achieved by ensuring proper installation and maintenance of the cable. This includes the following steps:
- Verify that the cable is properly connected to both ends of the network device. This means that the connectors on both ends of the cable are securely plugged into the designated ports on the device.
- Make sure that the cable is not bent or twisted at any point, as this can cause damage to the cable and reduce its stability.
- Keep the cable away from any sources of electromagnetic interference, such as power cables or other electronic devices. This can cause interference with the signal transmission and reduce the stability of the cable.
- Regularly inspect the cable for any visible damage, such as frayed or broken wires. If any damage is found, the cable should be replaced to ensure maximum stability.
- Properly store the cable when not in use. This means keeping it in a dry, cool place and avoiding any excessive bending or twisting.
Connector Types and Pinout Configuration
J9735A HP 2920 1m Stacking Cable is a type of connector used to connect multiple HP 2920 network devices together in a stacked configuration. The cable has a length of 3.28 feet (1 meter) and is equipped with two connectors on each end, one for the primary device and one for the secondary device.
The connector types used on this cable are SFP+ connectors, which are small form-factor pluggable connectors that are commonly used in high-speed networking applications. These connectors are designed to provide a high-speed, low-power, and low-cost interface for connecting devices in a stacked configuration.
The pinout configuration of the J9735A HP 2920 1m Stacking Cable is designed to ensure that the primary and secondary devices are properly connected and that the data can be transmitted and received between them. The pinout configuration includes both power and data connections, which are necessary for the devices to communicate and function correctly.
Some of the important pinout configurations of J9735A HP 2920 1m Stacking Cable are:
- VCC: The power supply pin for the connector.
- TX+: The positive data transmission pin for the connector.
- TX-: The negative data transmission pin for the connector.
- RX+: The positive data receiving pin for the connector.
- RX-: The negative data receiving pin for the connector.
- GND: The ground pin for the connector.
Product Information J9735A
- Manufacturer: HP
- MPN: J9735A
- Type: Cable
- Sub-Type: 1 Meter
- SKU: J9735A
